How to Program a Message on a Handheld Controller (No Quick Program)

Synopsis: If your Ver-Mac message board has a handheld controller, follow these steps to program a message. This is for the controller version without the Quick Program feature.

• Level: Intermediate
• Time required: Less than 5 minutes
• Additional equipment required: None

1. Log in to the handheld controller with the default password

Figure 1 - Login screen

2. Go to F2 - MESSAGE

Figure 2 – Main menu

Figure 3 – Message menu

3. Press Enter key, type in your message number (001, 002, 003, etc.), then type in your message

Figure 4 - Message number and message

Figure 5 - Enter key

Next, you will need to add your message to a sequence

4. Go to F1 – SEQUENCE and select a sequence between 1 & 8, then press F1 - EDIT

Note: Sequences 0 & 9 cannot be edited

Figure 6 – Main menu

Figure 7 – Sequence selection

5. On the Sequence page, press Enter, then type in the message number of the message created in Step 3

Figure 8 – Sequence menu

6. Activate your Sequence by pressing Enter, then ESC until you see UPDATING SEQUENCE

Figure 9

6.1. Your sequence can have a maximum of 6 messages/pages

6.2. If your sequence does not activate, log out of the handheld controller and check if the Status = Normal

If you require any additional help, contact our toll-free number at 1-888-488-7446 or email us at [e-mail]